Extreme Metal Products » 2014, Can-Am, Commander

Copy and paste this link for a waterproof demonstration

https://www.dropbox.com/sh/d9c8dv7yptdd2c0/AABLJfcVtEJthg4GGDRYY4L-a?dl=0&preview=Viper+Elite+HD.mp4

Plow blades are 20" high (higher than others) and 72" wide.

The Mold boards are made from 14 gauge steel and with 1/4" thick laser cut braces. They feature manual angle adjustment (left, right, center positions) or an optional Electric over Hydraulic power angle (sold separately). Our wear blade is made from AR plate (Abrasion Resistant Steel) and are 4" high. Others are much thinner and shorter, wearing out much sooner.

Our plow frames are Laser cut from 1/4" and 3/8" inch thick steel. The parts fabricated with the tab and slot method. In other words, the parts fit together like a puzzle before welding. This ensures a perfect fit every time.

Our Commander mounting system mounts to the front and underside of the Commander with the supplied hardware. The mount can easily be removed at the end of the season with four bolts. The plow attaches in less than a minute with the supplied hitch pins.

(Residential Consumer use only. Do not “Ram” plow or use vehicle speeds in excess of 5 mph.)

Optional power angle sold separately.

The Speakers are a 6-1/2" Water resistant Marine Design with 40 Watt Peak Power.

Watch this video for mounting reference only. It is similar but with a Sony stereo that is no longer available.

Thermoformed from 3/16" thick Polyethylene makes it very tough. Polyethylene is the same plastic used to make ATV fenders. Styled to match the factory fenders and body panels. It attaches with Rubber Coated Metal Straps

NOTE: 2010-2013 models would use #12125, same design, just different mount locations. Will not fit the X3.

The last picture shows the gussets on the 2014 model cage(for reference only).

Mounts to your cage with rubber coated mounting hardware. Laser cut and CNC formed to ensure a consistent fit. Two piece construction allows the top to ship via UPS to your door. Two LED dome lights light up the passenger compartments at night. Gasket seals between the front and rear sections.

NOTE: These are made to order. Please, allow 5-10 business days to ship. If you need it right away, please call and check stock before ordering.

There are no returns on these because they are made to order.

After you install the clamps on your cage you can easily remove your windshield without any tools. Simply, remove the thumbscrews and the clamps remain on your cage.

If you have any other model, measure your tube O.D. before ordering.

Note: The cross tube on the Viking and Wolverine is 1-1/2” and the side tubes are 2”. This will fit the side tubes only.

NOTE: You must use the harness exactly as specified in the instructions in order to be as safe as possible. Failure to properly use the harness may result in injury, or possibly death.

To be used on "Cooter Brown" (MR-10 Hard Coat Lexan) and glass windshields only.

Note: The cross tube on the Viking and Wolverine is 1-1/2” and the side tubes are 2”. This will fit the side tubes only.